On Jun 8, 7:03*pm, "Paul Remde" wrote:
Hi Frank,

I have seen that a few times. *It normally goes away when I edit the
turnpoint sectors to reflect those used in the flight. *To do that in
SeeYou, go to the Edit menu and select "Flight Properties". *Then go to the
Observation Zone tab.

I think there are other tips to getting past the issue, but I don't remember
them at this moment. *I'll think about it. *It may have been other settings
in the Flight Properties windows.

Best Regards,

Paul Remde
Cumulus Soaring, Inc.

"Frank" wrote in message

...



I flew a TAT today at the Cordele, Ga USA contest, and as I always do
I opened my flight in SeeYou 3.95 for analysis. *Except this time it
showed a 'photo landing' between the 2nd and 3rd turn areas, and there
seems to be no way to get rid of it. *I have been using SeeYou for at
least 8 years, and am pretty familiar with the common sorts of task
declaration errors that can lead to this situation. *However, this
time I can't get rid of it for the life of me.

I attempted to post this on the Naviter support forum, but that seems
to be screwed up too. *I can't get an activation email, and since I
can't get an activation email, I can't complete the forum registration
and therefore can't post. *I also looked at their forum postings about
'photo landings' and it seems that the SeeYou folks aren't really
interested in addressing this issue (assuming it *is* an issue and not
just something I'm doing wrong).

Anyone else had this *problem with SeeYou 3.95?

Frank (TA)

Paul,

Been there, done that ;-). I have also seen 'photo landings' when I
didn't have the task set up properly, or I forgot to change the task
type to 'Assigned Area Task'. However, I have done all that properly
(or at least I have double and triple-checked the settings and can't
find anything wrong).

Very frustrating. I just upgraded from V3.81 to V3.95, and I'm
beginning to wonder if there is some new setting in 3.95 that I don't
know about.

Frank (TA)