"Roger Halstead" wrote in message
...
On Thu, 30 Oct 2003 23:56:10 GMT, "Blueskies" wrote:

I am putting up a 48x48 'hanger' with radiant heat floor. Just now
getting to the wiring stage. I've got pictures of the
construction but no where to post them...

Roger, what did you seal/paint the floor with? I need to do that soon
before it gets too cold or wait 'till spring...

First I pressure washed it, then acid etch followed by another wash.
Gave it 3 days to dry with the heat on, and then gave it three coats
of 2-part epoxy from Lowe's. Other than that I used no sealers.

Roger Halstead (K8RI EN73 & ARRL Life Member)
www.rogerhalstead.com
N833R World's oldest Debonair? (S# CD-2)

Right. Make sure to use no sealer, as that could interfere with the epoxy.
Best to wait 30 days to put down any epoxy, to let the concrete finish 99%
of its cure.
--
Jim in NC