On May 18, 2:31*pm, Randy wrote:
I put a lot of miles on my Cobra trailer every year going to
various soaring locations. The hole that the sliding latch
uses to secure the lower tailgate, it getting larger with every
mile on the road. I've thought about using a latch similar to
the latches used on my tail dolly, but I want to see what
other guys are doing.

Your suggestions are very much appreciated.

Randy Teel
N304BU

http://talihinasoaring.com/

Drill the proper sized hole in a replacement peace of aluminum (or
steel) and then pop-rivet it over the big hole...............OR remove
the latch and pop-rivet it in place an inch or two lower, then drill a
new hole in the side member.
JJ