On Tuesday, June 19, 2012 5:07:12 AM UTC-7, kirk.stant wrote:
I'm learning how to setup Winscore for a local club fun contest. So far it makes sense, but setting up the Finish Cylinder is a bit confusing. How do I set it up for a 500' agl min finish height? The finish settings have settings for the Top and Base of the Finish Gate Cylinder, both in ft MSL.

Kirk
66

Kirk,
You may want to consider a finish cylinder base at 700AGL/1sm + 200'/sm if bigger. You do not want to tempt someone to start thermalling at 300' at the edge of the cylinder so they get a speed finish.
QT
QT