I've managed to lock my Vertica 2 PNA up with WinPilot, and can't get it un-frozen. Holding down the power button, even for an extended period doesn't do anything. Anyone know if there is a reset button?

If anyone else is trying to run WinPilot on a V2 in Landscape mode, DON'T launch the Declaration Transfer dialog! That particular dialog's 'OK' button is partially off-screen on the bottom and almost inaccessible. However, if you try to move the dialog up a bit so you can see/access the 'OK' button, it actually goes *DOWN*, and then the OK button isn't accessible at all, ever.

TIA,

Frank (TA)