On Sunday, May 5, 2013 8:10:35 AM UTC-7, wrote:
On Saturday, May 4, 2013 9:48:06 PM UTC-5, wrote: Installed the core and 57mm butterfly display today. Upgrade to 2.79 went smooth. Tried to upgrade the butterfly display to 3.01 from the core. Negative on the butterfly upgrade. The release notes say it does update from the core. I could not find any special procedures. The website says version 2.8 should also upgrade the butterfly directly from core.. so maybe the next release. Antenna's mounted on glare shield of V2. Let me know if anyone wants some pics installation. Stephen S9 Just tried updating the Butterfly display again with update file in the root of the USB Stick connected to the core. (I am not using the Butterfly update cable). I tried first by just turning on the core. No update on the Butterfly. I next tried holding the knob in on the butterfly display and then turning on the CORE unit with USB stick connected. The Butterfly display said "UPDATE Mode" and scrolled across the screen "Wsiting" . Nothing happened after 10 minutes of waiting. Now the display does show 3.0 Is my procedure right? S9

Updating with PowerFLARM®
(Updates through PowerFLARM will be available early summer 2013 with
PowerFLARM Software 2.8)
Butterfly firmware/FlarmNET update on Co
1. Copy Butterfly firmware (.bfw) and/or flarmnet (.bfn) to a USB stick.
2. Connect stick to Core.
3. Switch on system with BF display knob pressed.
4. Verify BF display goes into UPDATE MODE with 'WAITING', then 'LOADING'.
5. Wait until BF display restarts (can take up to two minutes).
Butterfly firmware/FlarmNET update on Portable:
1. Copy Butterfly firmware (.bfw) and/or flarmnet (.bfn) to micro SD card.
2. Insert micro SD card into slot.
3. Activate menu entry Info - Disp. update.
4. Switch on system with BF display knob pressed.
5. Verify BF display goes into UPDATE MODE with 'WAITING', then 'LOADING'.
6. Wait until BF display restarts (can take up to two minutes).
PowerFLARM

Richard
www.craggyaero.com