On 08/11/2013 4:17 PM, Andy wrote:
Changed to knob at right orientation. Waited for ADS-B target to be displayed. ADS-B target(s) displayed ok. While ADS-B target displayed, selected knob at bottom orientation. Immediately entered reset loop.

Andy



I did my first flight with display fw 3.2.1 (portrait orientation) on
Saturday. After about two hours the display went into the cycle mode as
describe above for a few minutes, it then stopped cycling and resumed
normal operation. The PowerFLARM core (fw 3.31) did not cycle, just the
display.

Luke