On Friday, March 18, 2016 at 1:20:14 PM UTC-4, Dan Marotta wrote:
It was a typo.* It's an LX-7007 Pro IGC.* I didn't see any obvious
card reader slot but there is a 5-pin DIN connector (male pins) on
the panel next to the computer.* If there's a card reader that plugs
in to that connector, I guess I need to find one since I haven't
found one in the ship.* I've asked the previous owner (a corporation
in Mexico) to look for the box that the computer came in (not
originally in the glider when new) and send it to me.




On 3/18/2016 5:59 AM, Andy Gough wrote:



On Thursday, March 17, 2016 at 2:51:34 PM UTC-4, Dan Marotta wrote:


My new (to me) Stemme has an LS7007 Pro IGC installed but no data
bases loaded.* I see a 5-pin DIN connector on the panel near the
control head but no cable came with the aircraft.* Does anyone out
there have a spare that they would like to sell or donate to the
cause?

--

Dan, 5J


If you made a typo and you actually have an LX7007 then you do not need a cable. Files are loaded on an SD card.

www.lxnavigation.com/manuals/






--

Dan, 5J

Go to.... http://www.lxnavigation.com/manuals/ , about 2/3 of the way down is the manual for your unit.
It also states that all units shipped AFTER September 2006 have the SD card slot, is your's does not have one it's an "easy upgrade".

They also state that a "PC compatible comm cable" is available in any PC store.

Late in the manual (~pg 100) they go over various connections for PC, PDA & SD card.

Hope this helps.