Charlie - Two comments on your comments.

1) These are nice since they've harder to short out.....
http://www.mouser.com/ProductDetail/...zIEaApPW8P8HAQ

OHM - When I use these I crimp on "pin" terminals rather than sticking the bare wire into each hole.

2) These can be used with ring or fork terminals.....
http://www.mouser.com/ProductDetail/...NsEaAm_D8P8HAQ

OHM - Use only ring lugs. After months of flying vibrations the screw holding the "Spade" (fork) terminals will back out slightly and the terminal will fall out.