Have a LX9070 and a PowerFlarm brick. The PF is turning on can see the red light when new software was loaded and can see a green light when it is on.. There are connections from Flarm to the LX9070 they appear solid, but when I go to the setup page on the LX9070, Hardware then Flarm all I see is a baud rate of 19200 and Ext.(PC). The Freq (should be North America, is blank) serial number and Version are blank. I did have another pilot say my Flarm was working as he got a Flarm warning, but I am not sure it was the Flarm or the transponder setting off his Flarm. I receive no data of the LX9070.

Does anyone know if there are other settings that would keep the Flarm from showing on the LX9070. As stated above all the indications are the Flarm is powering on.

Any help would be appreciated.


Kind regards,
Jon