On Friday, May 31, 2019 at 7:53:14 AM UTC-4, wrote:
OK.....I would turn on, load task, turn off.....back on with sometimes less than 10 mins to launch to save battery power (bad habit from using non LiPo batteries).
This is probably the cause of my issue as it just started.
I was doing it because my CN shows 11.2 volts, but my Dittle radio shows 12.4 on LiPo bat.
Thanks for info.
R

You might want to check the wiring to/from the CV (esp the ground). 1.2 volts is a lot of difference IMO.