Plastic/Vinyl letters
Heat works but I'd use a hairdryer instead of a heat gun. You just need to
get it warm and the letters should peel right off using your fingers. A
heat gun is overkill.
Bill Daniels
"Papa3" wrote in message
oups.com...
Mel,
By the title of your post, I'm assuming these are decals. Also,
assuming you've purchased a glass ship.
The letters I've worked with come off reasonably easily with plain old
mechanical methods (ie. peeling). It may help to use a heat gun on
LOW to soften the adhesive and material a little, but be very careful
not to get the surface too hot; if it's too hot to comfortably touch
it's too hot. You can use a plastic scraper to help things along.
The kind sold for mixing up plaster or bondo honed to a sharp point
work great. Final cleanup with a little bit of acetone on a rag
followed by a rinse with some H2O will get rid of any residual
adhesive.
Hope this helps.
Erik Mann (P3)
|