On Mon, 29 Aug 2005 22:36:52 GMT, Mike Spera
wrote:

Struts on a Piper main usually run 210 lbs. unloaded (strut fully
extended). This rises to around 550lbs at "normal" height. Yes, you
could have an upper air leak. More likely (if you have noticed seepage)
is that the main lower seals are wearing. You could have both. If you
see a small puddle, its usually the main lowers. No puddle and it may be
the upper seal washer OR the valve core itself. Don't try to use
automotive cores, they are not made for this application and pressure range.

Granville will help seeping lower seals to soften up and seal again.
Given the low cost of new seals (less than $100 for all 3 on a
Cherokee), I opted to just replace the seals. A messy 1/2 day job made
easier if the plane is up on jacks. Also, putting in Granville requires
a bit of work. Since mine were 25+ years old, that was the clincher for
replacement.

Good Luck,
Mike

Thanks for the info. Ordered a seal kit today and after reading the
manual it doesn't seem like too bad a job.

z