I'm at the same point on my cowling.
I have about decided to shoot the inside bottom with Epibond.
White in fact.

Holds up well agains laquer thinner, mek, acetone, etc.

Easier to clean too.


Richard
http://www.flash.net/~lamb01


Paul Lee wrote:

I have a composite cowling. There are some places where fuel or oil
might drip - for example below carb if overprimed. I would like to
simply paint that area inside or cover it with fuel resistant stuff
with a drain hole. Would any common paint do? Do I have to use the
tank sealer stuff - I don't need that much.

Paul Lee
------------------
SQ2000 canard project: www.abri.com/sq2000

--
Richard Lamb

http://www.flash.net/~lamb01/