On Nov 11, 4:09*pm, "John Bojack" wrote:
Here in the states I find it impossible to find metric hole saws.....so,
what have others done when cutting new panels for 57mm instruments?
Thanks!
J4
John,
Go to
http://www.craggyaero.com/ultimate.htm
Download the 2.25" and 3.25 Instrument hole templates at the bottom of
the page and follow the directions.
A 2.25" hole saw will work fine mark the center hole as in the
directions and us small pilot drills for starter holes then the 2.25"
hole saw then the instrument screw holes.
Make sure and use a punch to get the starter holes exact.
Richard
www.craggyaero.com