I have a hand held ICOM IC-A3E with a throughly dead battery pack.

In the past I've revived similar packs (e.g. on an HP-25 calculator) by
cracking into the plastic shell of the pack and replacing the cells,
which are usually AA size NiCds. Doing this is normally vastly less
expensive than buying a new pack.

So, before I dig out the heavy duty modeling knife and screwdrivers and
start levering at it, do any of you know how to get into these ICOM
battery packs without damaging them? I can't see any obvious clips,
catches or screws on the pack.


--
martin@ | Martin Gregorie
gregorie. | Essex, UK
org |