mhorowit wrote:
Dan wrote:
mhorowit wrote:
Roger wrote:
On Tue, 02 Jan 2007 10:10:23 -0500, Michael Horowitz
wrote:

Place the v-block on the drill press, lower the drill bit until it
bottoms in the V, clamp the v-block down and every single cylindrical
object placed in the v-block will be drilled through the center.

Dan, U.S. Air Force, retired

Duh, of course. Thanks - Mike


I know the feeling. I have days when I make some rather elaborate set
ups on my vertical mill then have a eureka moment like that It's best
not to have a witness around at times like that.

Dan, U.S. Air Force, retired