Thread
:
Fixing the Transponder with Duct Tape and Aluminum Foil
View Single Post
#
29
March 10th 04, 03:56 AM
Jim Weir
external usenet poster
Posts: n/a
If you do this, I GUARANTEE you that the noise will go away. This is a
trans-ponder. The trans part means that it responds ONLY to an input pulse. No
input pulse from a radar, no output pulse.
Wanna try again?
Jim
(John)
shared these priceless pearls of wisdom:
-Ron:
-The easy way to tell if the interference is coming from the radiation
-of the antenna is to disconnect the antenna at the antenna and connect
-a 50 ohm UHF rated dummy load in place of the antenna.
Jim Weir (A&P/IA, CFI, & other good alphabet soup)
VP Eng RST Pres. Cyberchapter EAA Tech. Counselor
http://www.rst-engr.com
Jim Weir