Kjell Sivertsen wrote:
Over some time the bolt holes in the link between the horizontal
stabilizer
and the trim mechanism have been elongated. To get rid of the play, I
consider installing an oversized bolt. The original bolt is an AN5-7.
I am
confused about the designation on oversized bolts. Can anyone help ?
Thank you in advance.
Kjell Sivertsen
Kjell,
Several NAS and MS bolts are available in diameters 1/64 inch oversize
(also 1/32 over). The advice from others that making the hole larger
may weaken the part too much is correct, and you have no real way of
knowing that. Getting a suitable bolt is not much of a problem. To
assure that the link is strong enough, you may have to replace it.
Regards,
Bruce Cunningham
N30464 C177A
|