On Mar 6, 6:00*am, "noel.wade" wrote:
Hi All,

I have an old Becker AR3201 that's working fine; but I managed to
slice a few of the wires in the harness while re-wiring my glider this
month (I decided it was time to get the rat's nest of PVC wire and old
tube-type fuses out of the cockpit). *A blade-type fuse on the
battery, Anderson power-pole connectors, and a few circuit breakers
all connected with Tefzel wire make for a much cleaner setup!

Anyways - Since the model 3201 has been discontinued, I haven't been
able to find any source of pre-fab wiring harnesses (at least, not
online). *I _could_ repair the harness myself with some careful
soldering, but a new harness would be a lot nicer (especially since I
have a gooseneck mic, a stick-mounted PTT switch, and the Becker audio
box mounted aft of the spar carrythrough area... so there are a lot of
wires to be hooked up properly and deliver a clean signal).

Any thoughts or suggestions?

Thanks! *Take care,

--Noel

It's time to re-wire the harness your self. That's what I had to do
when I bought mine used. It's not that hard to do. Post if you need
a copy of the manual or wiring diagram.

Todd Smith
3S