Hi Andy!

It’s been a couple of years since you posted this. I’ve been printing for a few months now but definitely still a newbie. However I decide to try to print your wing tip wheels just in plain PLA just to see what it looks like on my 27. Unfortunately, i have tried pulling the STL file into both Cura and FreeCAD. In each the models come up VERY small. There’s no measure tool in Cura but I was able to measure in FreeCAD and the length of the lower/larger parts measure around 2.74 mm. :-). So was wondering if A. I was doing something wrong or B) if you knew what scaling factor would bring the models up to the correct size for printing?

Thanks in advance!

-Mark