"Jerry H." wrote in message ...
wrote in
:


I have seen flying used R22's as low as $25K. I think you should look
around before spending $120-$140K on one. New, they go for about
$180K the last I checked. There is a 1200 hour major service that
costs about $80K to do. I hear it involves relplacing a lot of
expensive parts such as the main gearbox, rotor blades, etc.

The reason they are more money than a prop plane is because there is a
lot more to them and also because of product liability insurance. Its
a lot easier to get in trouble with a helicopter than a fixed wing.
And to add further insult to injury, fixed wings usually can carry a
great deal more cargo weight and get better mileage too.


A brand new R-22 with the common options (aux fuel, com, transponder,
GPS, and cabin heat) costs $176K. At 2200 hours or 12 years (whichever
comes first) it has to be overhauled. The factory will do this for about
$95K. It will then look and fly like new and be good for another 2200
hours or 12 years. The second time it costs a little more to overhaul
because a few more components are scrapped (tail boom, part of the frame,
etc). A run-out late model is worth somewhere in the $40k range. The
value of a new one goes down from $176k to $40k pretty much in a
straight-line fashion based on how much time it has until overhaul. Of
course there is some variation due to appearance, maintenance history,
and how it was used.
____________________________________________
The overhaul, by the way, is not optional.
____________________________________________

The 12 year Robinson recommended overhaul/inspection is not mandatory
for FAR Part 91 flight instruction & private operation.
Notice N8600.40 paragraph #4 specifies that : " if a manufacturer's
buletin or document recommends a TBO and it is not specified for
compliance on the Type Certificate Data Sheet or specific in the Time
Limitations Section for that component, it is left to the discretion
of the aircraft owner/operator to comply with that recommendation
under part 91"
Robinson does not make the flying rules, FAA does!
2200 hrs fatigue life-limited parts of R22 : main rotor blades(A016-2
10years, A016-4 12years), coning hinge bolts, pitch horn screws, gear
ste of tail rotor gearbox, main rotor spindles 2415hrs
Rest of components have 4400 hrs & better service life limit
Robison recommended 12 year overhaul/inspection must be complied with
for part 135 & 141 operation