Had an old timer tell me that a wet drill bit dipped in baking soda works to
drill Stainless.

"sleepy6" wrote in message
...
In article ,
says...

"Bob Babcock" wrote in message
. com...
Could I get some advice on working stainless steel and its propertie
s?
I want to work sheet and plate to about 1/8 thickness and have foun
d
this stuff very tough in the past. How would one drill and cut it
with good results in a homebuilders shop? What types of saw blades
and drills work best? I do not own a metal bandsaw yet but it is
probably going to happen. Can this stuff be cut with a hacksaw?

Also which stainless is good for fittings and such?
Thanks from Canada
Bob

The most important thing to learn about stainless is that it work hard
ens
instantly. Let's say that you are drilling a 1/8" hole with a typical
1/4"
capacity electric drill motor. If you pull the trigger, then set the b
it in
the centerpuch mark and start to apply pressure, you're all done for t
he
day, pal.

You *must* use a variable speed drill, place the bit in the centerpunc
h
mark, apply *lots* of pressure, and then *slowly* start the bit turnin
g. It
must cut into the metal with every turn. If you "skid" the bit over th
e
metal - even once - it will work harden to what seems to be the consis
tancy
of a diamond.

Same story with a saw.

You will probably get a lot of conflicting information about this and
arguments about which alloy of stainless will act this way and which w
on't.
But if you follow this procedure you won't go far wrong with any alloy
stamped CRS (Corrosion Resistant Steel).

Rich "Gimme another cobalt bit - this one's as dull as my _______" S


Yep. The trick is to keep the speeds slow and enough pressure that a
thin continous chip curls out.....Plus a good bit sharpener Use
finer teeth on the saw blades and expect them to wear out quicker than
normal. Bimetalic blades are worth the extra cost. Regular cutting
oils aren't very good with stainless. Keroscene makes a good drilling
or sawing fluid but it's dangerous. There are other products out there
that are designed for stainless cutting but I don't remember the names.