On Oct 22, 8:01*am, "bumper" wrote:
Yup, what JJ said. The "red stuff" is Mil Spec 5606 hydraulic oil and is
compatible with Buna-N O-rings and seals. It's also commonly used in the USA
for most small GA aircraft.

DOT automotive brake fluid, the "clear stuff", most often glycol-ether
based, and is compatible with EPDM rubber seals.

If you are switching parts from one fluid to the other, you gotta change the
rubber stuff.

bumper

"JJ Sinclair" wrote in message

...



Why didn't it work, Mike? Hydraulics are hydraulics, the Clevland
brake slave cylinder doesn't know (or care) where that pressure is
coming from? Make sure you have compatible seals. What type fluid does
BMW use? Can't mix the red stuff with the clear stuff.
JJ

Mike McCarron wrote:
JJ,

I did purchase a master cylinder from a BMW motorcycle dealer that did
fit
in place. *Unfortunately it did not function properly. *It was properly
bled and all but it did not work. *I don't know what to do next. *There
must be at least 100 of these gliders in the US that will need a master
cylinder replacement in the future. *I don't see how we can junk a $30K
glider for lack of a functioning master cylinder.

Thanks for your comment,

MC

At 13:41 22 October 2008, JJ Sinclair wrote:
If memory serves me, its a motorcycle master cylinder BMW? I believe
they cut it down from the original, good luck getting your inspector
to sign off on installing it!
JJ

Mike McCarron wrote:
My club has a 1983 Grob 103 Twin II that needs a new master cylinder.