Hi,

I recall a situation where the unit would power-up and show a big "Q" on the
screen but never get past it. I found a tip that a removing both batteries
and waiting about 10 minutes would cause a hard reset and it worked for me.

Paul Remde
Cumulus Soaring, Inc.
http://www.cumulus-soaring.com

"TowPilot185" wrote in message
...

There was a document on the HP web site that addressed this situation.
From memory, the solution was to remove the batter, Press the reset
button 3 times, then replace the batter. That would usually wake the
old iPaqs back up again.




--
TowPilot185