In article
,
Lou wrote:

I'm building a wood and fabric plane that uses plenty of aluminum
fittings and
hinges. If I have an aluminum block on one side of a spar made of wood
and the aluminum hinge on the other, with a bolt going through, is
there
any reason for washers? It's not that I wouldn't use them, but it
helps when
ordering the correct size bolt. The plans don't mention washers but
the plans
don't call for a few items that seem to me to be necessary.
Lou

Good practice in wood structures calls for a sleeve through the wood
(epoxied into place), slightly shorter than the thickness of the wood,
and large-diameter washers on each side, to distribute the compression
loads from the bolts. It doesn't mater if you have a block or a washer,
as long as there is a means of distributing the loads on the wood.

--
Remove _'s from email address to talk to me.