Unless Bill has invented a perpetual motion machine, you can't get more
power out of a mechanical device (such as an automatic gearbox) than you
put in. You can gear that power down to get more torque, but the Skylaunch
winch depends on supplying the right amount of power (related to throttle
setting) for the given glider type and headwind component. The automatic
gearbox is only useful to provide some extra torque at low revs to get the
glider moving at the start of the ground run without stalling the engine.

Derek Copeland

At 22:45 12 July 2009, bildan wrote:
On Jul 12, 3:30=A0pm, David Chapman
wrote:

But other nonsense posted here . please help me, =A0...

A standard car auto gearbox has some magic power to automatically
adjust
the torque to the car wheels on reaching a hill, without changing
gear,
road speed or engine setting? What magic is that?


That 'magic' is called a torque converter which begins to slip and
multiply torque under increasing load. Stock units can double torque
to the wheels.

Modern transmissions use a torque converter locking clutch allowing an
even greater torque multipication factor after the clutch disengages
under load. The effect can be 4:1 or greater.

For basic info, see: http://en.wikipedia.org/wiki/Torque_converter

In addition, automobile engine torque curves have peak torque lower
than cruise RPM. As the vehicle encounters a load such as a hill, the
torque output actually increases as the RPM is pulled down by the
increasing load. The typical V8 used in glider winches has a torque
peak at about 1800 RPM.

The engine/transmission combination acts in exact opposition to what
is needed in a glider winch.