mbremer216 wrote:

I have recently started some instrument training and when doind timed turns
noticed quite a bit of discrepancy between the clock and the resulting turn
(over 20 degrees). While I may not have been spot on in maintaining the
turn rate via the needle & ball, there's no way I was that sloppy,
particularly since the error was similar with turns in both directions.

I'm just going to change it rather than fix it. Now the challenge is to
find a replacement that won't break the bank.

Rmmmm?

Maybe I'm just confused or you were unclear. This reads as if your timed turns
aren't coming out on the right heading, so you're replacing your heading
indicator. I hope I'm wrong.

Dave