On Saturday, July 11, 2020 at 12:02:01 AM UTC+12, wrote:
Is anyone still making eccentric wing pin tools,
I have a Nimbus 2 that is a bitch to get the wings in the last 15ml/ half inch even with everything aligned correctly on the marks.
With my self built electric wing rigger I can do everything but that last bit.
I am making her complete one man system

Gary

I thank everybody for the suggestions which I will work through as soon as
the rain stops and the ground firms up again.
My engineer says that my ship has very tight tolerances on all metal components
(no wear) which pleases him!
She has relatively low hours for her years thus little wear.
There are a couple of small areas the flap teflon seal tapes are starting to lift slightly,any suggestions (glues) to extend their life?

Gary