On 4 Feb 2004 18:30:44 -0800, (Daniel)
wrote:

Bob Chilcoat wrote ...
Thanks, Daniel,

I presume the "t" in the table is thickness? Someone in the RCM group
suggested heating the bend line to soften the temper. Anyone here try that?
I'll probably experiment a bit before I go to work on the final piece.



Hi Bob,

Yes, "t" stands for thickness. FWIW, given the nature of the project,
I'd just make life easy & calculate the setback and bend allowance
based on a 1/8" or greater radius. Wouldn't have to mess with a
torch, less risk to the workpiece & a less sharp (safer) corner in the
cockpit.

Daniel


Oops! I missed that one. Indeed, the lower case 't' does stand for
thickness.

O-ring