View Single Post
  #3  
Old November 26th 07, 09:35 PM posted to rec.aviation.rotorcraft
Maxwell
external usenet poster
 
Posts: 1,116
Default Helicopter trailer


"The OTHER Kevin in San Diego" skiddz "AT" adelphia "DOT" net wrote in
message news
On Sat, 24 Nov 2007 17:12:11 -0800, "Stuart & Kathryn Fields"
wrote:

Perhaps something akin to how off road cars/trucks are built, i.e. low
spring rates, high rates of damping.

I'm envisioning something using coil overs, but those tend to be
pretty long so the trailer might sit higher than you'd like.

Maybe use torsion bars instead of traditional springs? I know a lot
of race car trailers use this setup - as do we with our sims in a
trailer - with good result.

Perhaps the folks at Carson Trailer (They're in L.A.) can help with
some basics for a "roll your own" rig...



Maybe heavy trailer frame and light springs. Perhaps springs designed for
less weight, like a boat trailer. I have seen former boat trailers used to
haul ultralights with good results.

I always thought a boat trailer with a telescoping tongue might be good for
a rotor craft. Chock the wheels, pull a pin, and pull forward. You could
park your RV almost a full trailer length away, and never disconnect the
trailer.