|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
August 19th 03, 11:32 PM
|
|||
|
|||
Suggestions sought for prop gov repair
Our Hartzell prop governor on an IO-360 Lyc has developed a nasty little oil
leak around the control shaft. The company in Wichita that successfully repaired it many years ago is no longer performing this type of work. Currently we are considering sending it directly to Hartzell, but if good experiences have been found in the midwest, we would be interested. The prop and governor were overhauled in '98. (about 750 hrs ago). Thanks and reply to newsgroup. ks_av8r 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Terra Switch repair | George A. Graham | Home Built | 1 | October 25th 03 12:15 AM |
Threaded Mode