|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
September 28th 03, 07:11 AM
|
|||
|
|||
Windshield sealant
I need to seal my plexiglass windshield in a few spots and happen to have
some GE Silcone II sealant on hand. It is spec'd as low odor but releases methanol and ammonia as it cures. I have seen warnings against using regular silicone sealant since the acetic acid it releases can corrode aluminum, but I believe ammonia has a high pH (is basic instead of acidic.) Does anyone know if Silcone II is 'safe and effective' as a windshield sealant? 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Electric windshield defroster | Paul Lee | Home Built | 7 | September 4th 04 04:37 AM |
| Uses for jeffco sealant... | John | Home Built | 1 | July 21st 04 11:33 AM |
| Fuel line thread sealant | Paul Lee | Home Built | 7 | February 26th 04 01:44 AM |
| Can you say: Payne Stewart ? - Explosive Decompression? Try it yourself, numbnuts. | Howard Berkowitz | General Aviation | 8 | January 21st 04 12:13 AM |
| Yo! Fuel Tank! | Veeduber | Home Built | 15 | October 25th 03 03:57 AM |
Threaded Mode