|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
August 18th 11, 02:49 PM
posted to rec.aviation.soaring
|
|||
|
|||
Tubes in tail of Jantar 41s Standard
I have recently acquired a Jantar 41a. I was inspecting the rudder
assembly and found two 3/8 inch tygon tubes with what looked link copper plug assemblies on the ends. I should have taken a picture. Does anyone know what these are for. They are attached to the vertical stab just forward of the lower rudder hinge point. 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Jantar Standard Canopy | jmarc | Soaring | 9 | August 22nd 17 04:13 AM |
| Jantar Standard 41b N41BZ | dam zaw | Soaring | 4 | May 5th 11 12:01 PM |
| WTB: Standard Jantar or ASW-19 | Kevin Christner | Soaring | 2 | January 9th 11 05:51 PM |
| Standard Jantar 48-3 & One-Man Assembly | John[_27_] | Soaring | 6 | July 20th 10 02:31 PM |
| Jantar Standard 3 | Miguel Lavalle | Soaring | 9 | November 19th 03 12:01 AM |
Threaded Mode