|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
August 29th 04, 05:12 PM
|
|||
|
|||
Shinn brake lining/riveting/counterboring depth?
When counterboring brake lining sin prep for riveting them in place,
how much material should I leave in place between the bottom of the rivet head and the metal drum? These are Shinn brakes. - Mike 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Goodyear Brake Pucks - Cheap! | Ron Wanttaja | Home Built | 7 | July 16th 04 07:45 AM |
| Shinn brake linings - bonding vice riveting | Michael Horowitz | Owning | 0 | July 12th 04 05:47 PM |
| Building the Po' Boy Bending Brake | Veeduber | Home Built | 14 | March 1st 04 07:15 PM |
| Brake caliper flange | Stealth Pilot | Home Built | 5 | July 7th 03 05:19 PM |
| Brake line design question | Charlie Smith | Home Built | 0 | July 2nd 03 01:31 PM |
Linear Mode
