![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
![]()
You could call Airtronics at Clintonville, WI , 92nm nne of MSN.
715-823-2161 Jim "Alex" wrote in message ... Anyone have a good shop for installation of a stormscope in the Madison WI area? I'm looking for a shop that can: o Skin Map o Test & fix any interference issues o Wire a used unit (snipped wires and no manual). Thanks! Alex |
#2
|
|||
|
|||
![]()
I had mine installed at J.A. Air Center at KDPA in West Chicago. You
can call them at 630-584-3200. They've always done wonderful work on my avionics installations. |
#3
|
|||
|
|||
![]()
One other thing - used units often require extensive refurbishing and
recalibration of the antenna system according to Aviation Consumer. |
#4
|
|||
|
|||
![]()
Does anyone have a pinout diagram for a Stormscope WX10A?
|
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Good shops in Madison WI | [email protected] | Owning | 1 | December 7th 04 06:42 PM |
Garmin 430 Install Manual Wanted | Bill Hale | Aviation Marketplace | 1 | November 13th 04 12:18 AM |
Install a Garmin GNS430 or an "Apollo" GNS480 ? | Roy Page | Owning | 23 | October 26th 04 02:52 PM |
Hours to install S-TEC | Frode Berg | Owning | 4 | May 8th 04 02:08 PM |