|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
June 16th 12, 06:56 AM
posted to rec.aviation.soaring
|
|||
|
|||
PowerFlarm Brick - Can it send GPS sentences to SN10B?
Trying to install PF Sat 06/16/12 before flight testing Sunday.
PF sends NMEA sentences by default at 19200 on the DB9 serial connector. The SN10B manual says it must receive at 4800baud. Which device needs to be set? Is there a way to change to DB9 serial output on the PF (possibly through config file)? Or, will the SN10B "hear it" on the RX line at 19200? Sent same message to Dave Nadler... yet, he may be too busy right now at the Nationals. I'd prefer to drive the SN10B with the PF because then I can receive an IGC logger file from the SN10B. This provides a backup to my currently installed Volkslogger. Walt Rogers, WX Walt Rogers, WX 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| PowerFLARM Brick and PowerFLARM Remote Display Manuals Available | Paul Remde | Soaring | 30 | May 25th 12 11:58 PM |
| Any news about PowerFLARM Brick or Bright Oudie availability? | kirk.stant | Soaring | 4 | April 15th 12 12:13 AM |
| Any news on the "brick" version of PowerFlarm from the SSA convention? | Andrzej Kobus | Soaring | 7 | February 8th 12 04:29 PM |
| PowerFLARM 'brick' progress? | Frank Paynter[_2_] | Soaring | 5 | November 13th 11 07:28 PM |
| Display for PowerFLARM brick | Andy[_1_] | Soaring | 4 | May 10th 11 02:32 PM |
Threaded Mode