|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
March 24th 04, 03:35 PM
|
|||
|
|||
Cleaning up a reamed hole?
Can anyone advise me how I should clean up a 5/16th reamed aluminum hole to
eliminate stress fractures. Is the process called "burnishing" and how is it done? Will fine grade sandpaper work. This is an important wing fitting. Thanks. Larry 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Cleaning up brushes/dope? | Michael Horowitz | Home Built | 5 | June 23rd 11 02:11 AM |
| Cleaning the sprayer | Michael Horowitz | Home Built | 2 | August 26th 03 03:12 AM |
| Fairing question... | Tina Marie | Home Built | 5 | July 16th 03 12:18 AM |
Threaded Mode