![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
![]() |
#2
|
|||
|
|||
![]() |
#3
|
|||
|
|||
![]()
Strange you should mention 5:00X4 from Desser. I just finished mounting a
new 5:00 X 4 tire AND new tube from Desser for the nosewheel of an Ercoupe. I think they're the sole supplier of that size nowadays. Cheers: paul NC2273H .. Wanted--tube for the tail wheel tire for a Beech 18 Aircraft. Contact Ed at What size is it? Desser Tire & Rubber, in Los Angeles stocks all kinds of tires. I can even get 5.00X4 tires there. |
#4
|
|||
|
|||
![]()
On Tue, 1 Jun 2004 19:51:44 -0700, "Paul Anton"
wrote: Tbe 500x4 tire will fit the 12.50 SC (Smooth Contour) tailwheels that were/are on a number of vintage aircraft of the time period T-6, etc.). Airworthy (good condition / nylon) 12.50 SC tires are getting very hard to find, so short of going the P-51/T-6G tire/wheel route (even more expensive), the 500x4 is a viable alternative. I didn't know Desser was the only supplier, but that may explain the price of the 500x4 tires! Bela P. Havasreti Strange you should mention 5:00X4 from Desser. I just finished mounting a new 5:00 X 4 tire AND new tube from Desser for the nosewheel of an Ercoupe. I think they're the sole supplier of that size nowadays. Cheers: paul NC2273H . Wanted--tube for the tail wheel tire for a Beech 18 Aircraft. Contact Ed at What size is it? Desser Tire & Rubber, in Los Angeles stocks all kinds of tires. I can even get 5.00X4 tires there. |
#5
|
|||
|
|||
![]()
Desser also carries the 7.00x8 size for Navions. They're not cheap either!
Bela P. Havasreti wrote: On Tue, 1 Jun 2004 19:51:44 -0700, "Paul Anton" wrote: Tbe 500x4 tire will fit the 12.50 SC (Smooth Contour) tailwheels that were/are on a number of vintage aircraft of the time period T-6, etc.). Airworthy (good condition / nylon) 12.50 SC tires are getting very hard to find, so short of going the P-51/T-6G tire/wheel route (even more expensive), the 500x4 is a viable alternative. I didn't know Desser was the only supplier, but that may explain the price of the 500x4 tires! Bela P. Havasreti Strange you should mention 5:00X4 from Desser. I just finished mounting a new 5:00 X 4 tire AND new tube from Desser for the nosewheel of an Ercoupe. I think they're the sole supplier of that size nowadays. Cheers: paul NC2273H . Wanted--tube for the tail wheel tire for a Beech 18 Aircraft. Contact Ed at What size is it? Desser Tire & Rubber, in Los Angeles stocks all kinds of tires. I can even get 5.00X4 tires there. |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Tire question | Jay Honeck | Owning | 30 | February 8th 05 07:55 PM |
Tailwheel Crosswind Landing | Piloting | 32 | December 6th 04 02:42 AM | |
Rag and tube construction and computer models? | BllFs6 | Home Built | 24 | April 12th 04 12:20 PM |
Why 4130 tube? | Leon McAtee | Home Built | 31 | March 28th 04 03:04 PM |
Advice on flying Pitts with Haigh Locking Tailwheel | Ditch | Home Built | 19 | January 4th 04 10:18 PM |