|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
November 30th 14, 08:57 AM
posted to rec.aviation.soaring
|
|||
|
|||
Cambridge 302 - switch from Netto in cruise to TE in climb?
I have a CAI 302 vario and currently run it in Super Netto mode. However I would like to have it run as a Netto vario in cruise, and a normal TE vario in climb.
The manual says that a cruise/climb switch may be connected between Pin 9 and Pin 10 however I don't know if that will switch to TE in climb, or stay as Netto? Obviously I need to use the CAI utility to set the vario to Netto as a first step. 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Netto bis | bish | Soaring | 4 | August 14th 11 06:56 AM |
| Netto | bish | Soaring | 12 | August 4th 11 04:09 AM |
| cruise vs. climb article location | SAM AND LEIGH ZIMMERMAN | Soaring | 5 | March 19th 07 04:15 PM |
| Flap handle activated Climb/Cruise switching | Andy Smielkiewicz | Soaring | 5 | March 14th 05 04:54 AM |
| Cambridge 302 and Super netto | Ross Biggar | Soaring | 13 | September 13th 03 08:57 PM |
Threaded Mode