|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
February 16th 16, 05:59 PM
posted to rec.aviation.soaring
|
|||
|
|||
Breakers as Switches - Good Idea?
I often see GA and gliders that use breakers as switches. Is this such a good idea? Are breakers rated to be used as switches? These aircraft usually, but not always, have at least a master switch.
Our tow plane uses Tyco W31 series breakers which incorporate bat handles and are designed to be used as a combination of a breaker and a switch. http://www.aircraftspruce.com/catalo...?clickkey=5950 What say you? John (http://aviation.derosaweb.net) 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Good Idea? | Little Luke | Piloting | 1 | August 20th 08 05:22 PM |
| Pilots Uniform: Good idea?? | [email protected] | Owning | 16 | December 6th 07 08:44 PM |
| "Trying out" a different insturctor just to see - good idea? Badidea? | GEG | General Aviation | 18 | May 8th 05 09:33 PM |
| Is replacing Maverick with JCM a good idea? | Scott Ferrin | Military Aviation | 12 | June 16th 04 11:07 PM |
| Defrag before install a good idea? | Mark Cherry | Simulators | 3 | September 23rd 03 08:51 AM |
Threaded Mode