|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
May 11th 16, 12:04 AM
posted to rec.aviation.soaring
|
|||
|
|||
LXNAV NANO3 Error Bar
On the Waypoint page and the Task page my NANO3 has started showing an error with a red bar in the center of the screen saying INVALID CUB FILE.
I have cleared all files in the SetupFilesWaypoints, loaded new files which check ok on other applications and still cannot get rid of the error. Has anyone else experienced this and found a solution? 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| New RAM Mounting Arms for LXNAV FlarmView, FlarmView2, Nano, and Nano3 | Paul Remde | Soaring | 2 | August 20th 15 10:20 PM |
| LXNAV V7 and WinPilot Pro | [email protected] | Soaring | 6 | November 14th 13 03:35 PM |
| LXNAV Flarmview | [email protected] | Soaring | 2 | September 29th 13 01:47 AM |
| New vario by LXNAV | [email protected] | Soaring | 6 | May 22nd 13 11:15 PM |
| LXNAV V7 | Paul Remde | Soaring | 2 | November 2nd 11 12:31 AM |
Threaded Mode