|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
November 8th 17, 01:35 PM
posted to rec.aviation.soaring
|
|||
|
|||
Replacing tow release cable on Discus CS
Our Club's Discus CS frayed 3 strands of the tow release cable. I replaced that part and we're OK for now. We have a nose hook and no CG hook. I'd like to replace the whole cable. The path is convoluted and goes over one pulley that I can see after removing the cover of the front (back when looking from cockpit) part of the pedestal. The nose hook is behind a cover. It would be a great help if someone could send an E-copy of the complete anatomy and any "tricks of the trade". Will do this with supervision by A&P of course. Thanks in advance.
Hartley FAlbaum 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Replacing TOST release at 10K activations | 150flivver | Soaring | 23 | February 17th 14 08:43 PM |
| TOST Release Failure - Two Uncommanded Release's | [email protected] | Soaring | 11 | October 13th 12 10:23 AM |
| Duo discus tow release | XXL | Soaring | 1 | June 15th 09 01:02 PM |
| Replacing innertubes without replacing tires? | Ben Jackson | Owning | 28 | November 6th 06 04:54 PM |
| Discus CS and Duo Discus Wing Inspections | Nolaminar | Soaring | 0 | October 24th 03 01:15 AM |
Threaded Mode