![]() |
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
|
Where does one get those "doughnuts" that you put over instrument tubing to help secure and seal the connection?
|
|
#2
|
|||
|
|||
|
I've used safety wire for that purpose, being careful not to make it too
tight. On 8/7/2019 9:12 AM, soaringjac wrote: Where does one get those "doughnuts" that you put over instrument tubing to help secure and seal the connection? -- Dan, 5J |
|
#3
|
|||
|
|||
|
Vet
Agricultural supplier ebay They're intended to do nasty things to sheep At 15:12 07 August 2019, soaringjac wrote: Where does one get those "doughnuts" that you put over instrument tubing to help secure and seal the connection? |
|
#4
|
|||
|
|||
|
On Wednesday, August 7, 2019 at 8:12:19 AM UTC-7, soaringjac wrote:
Where does one get those "doughnuts" that you put over instrument tubing to help secure and seal the connection? Don't waste your time using those they are not needed. Richard |
|
#5
|
|||
|
|||
|
Exactly. Tubing should be silicone. No additional devices needed.
|
|
#6
|
|||
|
|||
|
On Wednesday, August 7, 2019 at 9:27:34 AM UTC-7, Tango Whisky wrote:
Exactly. Tubing should be silicone. No additional devices needed. I plan on using the colored tubing from Wings and Wheels. Good stuff? |
|
#7
|
|||
|
|||
|
Absolutely, very good tubing!
|
|
#8
|
|||
|
|||
|
On Wednesday, August 7, 2019 at 12:46:40 PM UTC-7, soaringjac wrote:
On Wednesday, August 7, 2019 at 9:27:34 AM UTC-7, Tango Whisky wrote: Exactly. Tubing should be silicone. No additional devices needed. I plan on using the colored tubing from Wings and Wheels. Good stuff? Craggy Aero also has tubing http://www.craggyaero.com/tubing_&_fittings.htm Richard www.craggyaero.com |
|
#9
|
|||
|
|||
|
I use silicon tube of 5mm ID cut into 10mm pices and stretched over the tube and fitting.
The rubber donuts deteriorate very quickly to the point of being useless. |
|
#10
|
|||
|
|||
|
The rubber rings are called docking rings.
|
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Source of green donuts for instrument tubing installation? | Movses Babayan | Soaring | 14 | April 10th 18 10:45 PM |
| Relesable instrument tubing | [email protected] | Soaring | 6 | February 13th 07 06:38 AM |
| source for clear+red instrument tubing | John W | Soaring | 8 | November 1st 04 02:19 PM |
| Tubing strength | Ernest Christley | Home Built | 0 | January 17th 04 12:43 AM |