|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
March 29th 05, 04:26 PM
|
|||
|
|||
Tach Generator Cessna 340
My RPM gauge does not show anything at startup on right engine. Then at
runup it comes to life at high RPM. Then after that it works fine. It wobbles a bit sometimes in the air. My take is that my tach generator is the problem. Any other ideas. Also do you know where to get a replacement unit or overhaul? 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Mechanical tach failure? | Rich S. | Home Built | 25 | November 6th 04 04:30 PM |
| Tachometer or Tach Cable | Rich | Owning | 14 | October 14th 04 03:54 AM |
| Analog tach replacement | Mike Noel | Owning | 12 | July 20th 04 11:20 PM |
| Logging Time Consistently - Hobbs AND Tach | Carl Orton | Piloting | 11 | June 29th 04 10:52 PM |
| Tach Vs. Hobbs Time | John Roncallo | Owning | 33 | January 7th 04 01:42 AM |
Threaded Mode