|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
September 4th 05, 04:59 AM
|
|||
|
|||
Dimensions NEEDED
Anybody know how the cylinder studs/ thru-bolts are located on the old
E-185-225 series Cont. Engines ?? Usually one of 2 ways, either a bolt circle diameter with so many degrees offset from a horiz or vert C/L of the bore of the cylinder-----Or, rectangular measurements from a horiz. and /or vert. line . Thanx ahead 'o time, muddled motor man 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| NY Go Kart Endurance Racing - Arrive & Drive - No Experience Needed | OVRPNY | Owning | 1 | May 19th 05 05:56 PM |
| NY Go Kart Endurance Racing - Arrive & Drive - No Experience Needed | OVRPNY | Piloting | 0 | May 19th 05 03:01 AM |
| builder assistance needed | AINut | Home Built | 0 | April 8th 05 08:05 AM |
| B-17 dimensions... particulars... | Ali-Reza Anghaie | Military Aviation | 1 | December 29th 03 06:05 PM |
| Bell Jetranger cockpit dimensions | HW | Rotorcraft | 1 | September 16th 03 11:49 AM |
Threaded Mode