|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
|
|
#1
September 22nd 05, 03:36 AM
|
|||
|
|||
Bendix Magneto Question
I have an engine going into a homebuilt that uses the bendix D-2000 series
dual magneto. I have ordered a crank triggered ignition system to fire one set of plugs and would like to replace the dual magneto with a single magneto to fire the other set of plugs. The Starting functions will be accomplished using the Electronic system so I do not need an impulse coupling or retard breaker. DOES ANYONE KNOW THE APPLICABILITY OF SINGLE MAGS TO REPLACE A DUAL MAGNETO? THAT IS, WHICH SINGLE MAG WOULD REPLACE MY DUAL? IF NOT, DOES ANYONE HAVE A CONTACT AT BENDIX THAT MIGHT BE ABLE TO ANSWER MY QUESTIONS? THANKS IN ADVANCE! Mag Type: D6RN-2230 Mag Part # 10-382610-121 System Part # 10-385286-401 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Bendix Magneto Question | Dick Kurtz | Home Built | 1 | September 22nd 05 08:51 AM |
| Bendix Magneto Question | Dick Kurtz | General Aviation | 0 | September 22nd 05 03:36 AM |
| Bendix Magneto Question | Dick Kurtz | Owning | 0 | September 22nd 05 03:36 AM |
| Bendix S4RN21 magneto | Heino & Deanne Weisberg | Home Built | 0 | August 12th 05 05:55 AM |
| bendix carb question | Dick | Home Built | 11 | June 25th 05 05:15 AM |
Hybrid Mode
