|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
October 15th 05, 09:51 PM
|
|||
|
|||
Engine Recomendations
Today was not a good day for the Baron. While replacing a cylinder I found
a crack (confirmed with Dye Pent) off the #5 cylinder leading up towards the case halves. The engine has 2750 Hr since new and about 1000 Hr since a TW Smith overhaul. The case is repairable, but it seems like a waste to not do the overhaul. The question is has anyone recently purchased a Factory New engine? The cost is about $4K more but the parts are not a mix of old parts. The engine is an IO-470L. Any thoughts and opinions will be a great help. Paul 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Gyrocopter Speed | Mark | Rotorcraft | 36 | August 17th 05 12:28 AM |
| Proposals for air breathing hypersonic craft. I | Robert Clark | Military Aviation | 2 | May 26th 04 07:42 PM |
| Car engine FAA certified for airplane use | Cy Galley | Home Built | 10 | February 6th 04 04:03 PM |
| What if the germans... | Charles Gray | Military Aviation | 119 | January 27th 04 12:20 AM |
| Real stats on engine failures? | Captain Wubba | Piloting | 127 | December 8th 03 05:09 PM |
Threaded Mode