|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
October 16th 05, 09:57 PM
|
|||
|
|||
Painting/prep Magnesium
I have some small spots on the mag elevators that need a bit of
touch-up. On the Aluminum I use a bit of Alodyne solution. Clean it well, then Alumaprep and then repeatedly wipe the area with Alodyne solution until it's gold colored. Then wash thoroughly. However, I don't know what to use in the case of Magnesium. Same stuff or what? Any socially acceptable suggestions? Roger Halstead (K8RI & ARRL life member) (N833R, S# CD-2 Worlds oldest Debonair) www.rogerhalstead.com 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Epoxy Bonding to Aluminum and Magnesium | Ryan Young | Home Built | 25 | September 16th 04 02:45 AM |
Threaded Mode