|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
November 28th 05, 06:21 PM
posted to rec.aviation.soaring
|
|||
|
|||
How to stiffen a limp gooseneck?
Our club flagship--a K21 has an aging problem. The gooseneck (for the
microphone) has gone limp. I have considered splints and ductape, but that is cumbersome and unsightly. I am looking for rejuvenation if possible. Replacing it is possible, but it looks like some fine wire splicing will be needed. Not impossible, but would prefer something simpler. Any ideas out there? TIA -- Hartley Falbaum 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Boom (gooseneck) Vs ambiance microphone | Ludovic Launer | Soaring | 12 | October 7th 04 04:20 AM |
| distributor for "osran" gooseneck light? | Doug Vetter | Owning | 5 | September 16th 03 10:02 PM |
Threaded Mode